John Lewis JLBIIH804 18T Instrukcja Użytkownika Strona 29

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 32
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 28
29
Repeated acoustic signal (6x), ap-
pliance switches off
One or more sensor fields have
been covered for longer than 10
seconds
Uncover sensor field
Acoustic signal sounds when ap-
pliance is switched off
The control panel is wholly or
partly covered by objects.
Remove objects.
Acoustic signal sounds and appli-
ance switches itself on and then
off again; after 5 seconds another
acoustic signal sounds
The On/Off sensor field has been
covered up, e.g. by a cloth
Do not place any objects on the
control panel
Display changes between two
heat settings
Power Management is reducing
the power of this cooking zone
See the section “ Switching the
power function on and off
Power Management is active,
maximum load per side reached
Use cooking zones on other side
flashes Unsuitable cookware Use suitable cookware
No cookware on the cooking
zone
Put cookware on zone
Diameter of the base of the
cookware is too small for the
cooking zone
Use suitable cookware (min.
120 mm)
Cookware not completely cover-
ing cross
Place cookware centrally over
the cross
is lit Overheating protection for the
cooking zone has been triggered
Switch off the cooking zone.
Switch the cooking zone on again
Automatic switch off has been
triggered
Switch off the cooking zone.
Switch the cooking zone on again
and number are displayed Electronics fault Disconnect the appliance from
the electrical supply for a few
minutes (Take the fuse out of the
house’s wiring system)
If after switching on again, is
displayed again, call the customer
service department
and minus are displayed Light rays that are too strong on
the control panel, for example
bright sunlight
Briefly shade the control panel,
for example with the hand
Acoustic signal sounds, appliance
switches itself off. Switch appli-
ance on (again)
Problem Possible cause Remedy
Przeglądanie stron 28
1 2 ... 24 25 26 27 28 29 30 31 32

Komentarze do niniejszej Instrukcji

Brak uwag